Loading docks and mezzanines have always been a necessity for businesses with shipping, receiving and storage needs. Most companies do not view loading docks or mezzanine loading areas as a safety concern, but these areas often present dangerous fall hazards. A common risk associated with loading docks and mezzanine loading areas is the fall hazard that is created when the area is not in use. Dock gates offer protection against falls from loading docks while mezzanine gates create a safe barrier for employees in elevated mezzanine loading areas.
Call for a quote! 843-261-0567 | info@afallpro.com 
Mez & Dock Gates
Mez Pivot Safety Gate
The MZ-Pivot Gate protects employees in elevated mezzanine loading areas. Its counterbalanced gates ensure that one gate is always between your employees and the edge of the platform. The MZ- Pivot Gate is available in single or double pallet widths.
Mez Clear Height Safety Gate
The MZ-Clear Height Safety Gate protects employees in elevated mezzanine loading areas with no height restrictions to accommodate tall loads. Its counterbalanced gates ensure that one gate is always between your employees and the leading edge, allowing you to load and unload material while keeping your employees safe.
![dock-gate-high-res[1]](https://atlanticfallprotection.com/wp-content/uploads/2016/02/dock-gate-high-res1.jpg)
Loading Dock Safety Gate
The Dock Gate provides protection against falls from loading docks. Custom gas struts make the vertical gate easy to open, and tapered guides on the receiver post make for easy alignment when closing. The Dock Gate is available in 8’ and 10’ widths.
![dual-vertical-lift-gate-high-res[1]](https://atlanticfallprotection.com/wp-content/uploads/2016/02/dual-vertical-lift-gate-high-res1.jpg)
Dual Lift Loading Dock Gate
The Dual Vertical Lift Gate provides wide coverage against falls while maintaining a height clearance. Gas struts make for easy operation and the gate is perfect for loading docks, mezzanines, or any large coverage areas. Locking feature provides safety from any push or pull resistance while exceeding 200lb of protection. The Dual Vertical Lift gate is available in 8’ and 10’ width coverage.
![VG-Series-vertical-lift-gate[1]](https://atlanticfallprotection.com/wp-content/uploads/2016/02/VG-Series-vertical-lift-gate1.jpg)
Vertical Lift Gate
The VG Series vertical lift gate is an easy to operate, industrial safety gate. Optimal for facilities that may not have proper clearance for an average swing gate, the lightweight VG Series is the OSHA- compliant solution. The VG Series vertical lift gate is available in 4′ or 6′ and comes standard with safety yellow powder coating.
Relevant ANSI and OSHA Standards:
•29 CFR 1910.29(b)(13) When guardrail systems are used around holes that serve as points of access (such as ladderways), the guardrail system opening: Has a self-closing gate that slides or swings away from the hole, and is equipped with a top rail and midrail or equivalent intermediate member that meets the requirements in paragraph (b) of this section; or is offset to prevent an employee from walking or falling into the hole.